Cedar privacy run with a picket gate
Two days on one property line: cedar dropped on the street, posts set in footings down a narrow side yard, the run closed in, and a picket gate built to sit beside the existing board fence.
The Site A narrow side yard with no room to cheat
The line runs down a side yard barely wider than the trailer that delivered the material, past a mature pine, with a utility post standing inside the run and an old board fence marking where the new one had to land. On a fence like this, access is the whole job: every board comes down the street, gets carried in by hand, and lands within a couple of inches of where the last one sits.
The other constraint is the fence that was already there. A gate set against an existing run has to clear it, clear the ground, and still swing true after the posts have settled.
The Build Two days, in order
- 1. Material on site: cedar boards and posts delivered on the trailer and stacked along the street before the first hole was dug.
- 2. Posts in footings: hole, concrete, post — set plumb in a straight line down the side yard, working around the pine and the utility post rather than fighting them.
- 3. Run closed in: panels and rails built onto the posts, keeping the top line level across the whole run.
- 4. Gate built and hung: picket gate assembled and set against the existing board fence, then adjusted until it swung clear and latched square.
- 5. Detail and clean-up: the corner by the downspout tidied, the work line cleaned, and the run walked with the homeowner.
The Result One line, two days
The run reads as a single straight line from the yard instead of a series of panels, the gate swings clear of the old fence beside it, and the posts sit in concrete deep enough to hold through a Front Range spring. Two working days on site, with the gate hung on the second.
Build photos
The build in the order it happened, from material on the street to the gate hung in the finished run. Click any photo to enlarge.
Need a fence that holds its line?
Posts set in real footings, panels built straight, and a gate hung to swing true the first time.
Request a Similar Project